Icom Ic-f310 Programming Software Jun 2026

Check Device Manager to ensure the COM port matches the software settings. Ensure the cable is fully seated in the RJ-45 jack.

Map the front-panel programmable keys (P0, P1, P2, P3) to functions like Monitor, Scan, or High/Low power toggle. Step 5: Writing to the Radio

This software is designed for standard non-"S" models (e.g., ) and serves two major functions: Icom Ic-f310 Programming Software

The primary software used to configure the series is the Icom CS-F300 Cloning Software . Buy Icom CS-F300 | Programming Software, DOS Version

Software alone cannot communicate with the radio. You need a specific hardware bridge between your computer and the transceiver. The Programming Cable (OPC-478) Check Device Manager to ensure the COM port

According to ameradio.com , this software is a DOS-based application essential for full control over the radio's specialized features. 2. Necessary Hardware for Programming

To bridge the gap between your computer's serial port and the radio's microphone jack, you need a specific cable combination. Step 5: Writing to the Radio This software

Original legacy cables featured a DB9 Serial connection. Modern computers lack serial ports, so you will likely need a USB-to-OPC-1122 cable .

Go to and save this original configuration file in a safe folder. Step D: Editing Frequencies and Settings

To successfully program your Icom IC-F310, you cannot use a standard USB cable. You will need a dedicated cloning cable to connect the radio to your computer.

Because the IC-F310 is an older model, finding the software requires checking specialized commercial radio dealers.